BPT Bullet Trap - Level IV

BULLET TRAP / GUN DISARMING CABINET

SPECIFICATIONS :

“MAKE YOUR FIREARM SAFE”
WITH A BPT BULLET TRAP!

TRAPPING LEVEL

This bullet trap is specially designed for the disarming of handguns and rifles at checkpoints in all areas where handguns and rifles are checked-in, e.g. Airports, Government Buildings, Shooting Ranges, Casinos, Gun Dealers, Mines, etc.

The bullets can be of any type for example: handgun – 9mm and 45 magnum, rifles – R4, R5, 12 gauge and 7.62 x 52mm amour piercing bullets as the Bullet Trap contains material that will “catch” armour-piercing bullets (as per example found below).

“CATCHING” MATERIALS

The “BPT” Bullet Trap contains a unique composition of “Kevlar”, Ceramics, High Density GRP and Polymers contained in a steel casing. The steel casing is surrounded by shock and energy absorption silica surrounded by a smooth moulded fiberglass.

EVALUATION

Both the SAPS Forensic Science Laboratories and the Amour Development Division of Armscor in Pretoria, South Africa, (L177, dated 14/02/2007) tested the BPT Bullet Trap using all ranges of handguns and rifles. All the findings were that the “BPT.Bullet Trap” met the requirements as a safety device to ensure safe unloading of firearms.

GENERAL

The bottom is provided with slip resistant Neoprene rubber foam to provide resistance to moving after a shot has been fired into it. As an alternative it is also possible to permanently bolt the Bullet Trap into position through the flanges on the side.

Bullet Trap Specifications:
Height : 260mm
Width : 275mm
Depth : 450mm
Mass : 20Kgs
Cylinder Size : 130mm Diameter